Consistency checking LCM

Welcome Forums DSC (Desired State Configuration) Consistency checking LCM

This topic contains 1 reply, has 2 voices, and was last updated by

3 years, 5 months ago.

  • Author
  • #30293

    Points: 0
    Rank: Member

    Hey Guys,

    Any secret tricks for troubleshooting consistency checking on an LCM? I have a group of 20 machines and all of them bar 2 are doing standard consistency checks. The two that are not working are just sitting on 'Initial' (after a push) and don't create any configurationstatus Mofs in System32\Configuration\ConfigurationStatus.

    I've tried removing all folders in the configuration folder and pushing config out again for those to re-create but unfortunately that doesn't help. All running PowerShell Prod preview 5.0 and all are Windows Server 2008 R2.


  • #30514

    Points: 1,811
    Helping HandTeam Member
    Rank: Community Hero

    Use the DSC diagnostics module to enable a diagnostics trace, and then look at the logs after the check runs next time.

The topic ‘Consistency checking LCM’ is closed to new replies.

denizli escort samsun escort muğla escort ataşehir escort kuşadası escort