Invoke-Command on remote isolated VM

Welcome Forums General PowerShell Q&A Invoke-Command on remote isolated VM

This topic contains 4 replies, has 3 voices, and was last updated by

 
Participant
8 months, 1 week ago.

  • Author
    Posts
  • #95522

    Participant
    Points: 0
    Rank: Member

    I've got this remote Hyper-V machine that I'm using as a lab server. Within this lab there are serveral virtual machines that run in an isolated lan and can only reach the outside world over a proxy, so connecting to them from the "production" network isn't possible. What I'm trying to do is remote into the Hyper-V host, and execture commands on the isolated VM's. I've figured out how to do that but's its a bit much if you ask me. I was wondering if there's an easier/smarter way to do it?

    Example:

    $session = New-PSSession -ComputerName whv -Credential (Get-StoredCredential -Target "HyperVManager/WHV") -Authentication Credssp
    $vmsession = Get-Credential -UserName "Administrator" -Message "Enter Credentials"
    $Bits = "Bits"
    
    Invoke-Command -Session $session -ArgumentList $vmsession, $Bits {Invoke-Command -VMName "Edge01" -Credential $args[0] -ArgumentList $args[1] {Get-service -Name $args[0]}}
  • #95555

    Keymaster
    Points: 1,638
    Helping HandTeam Member
    Rank: Community Hero

    That's pretty much how it's done.

  • #95634

    Participant
    Points: 0
    Rank: Member

    Hi Micheal waterman,

    I need help on VMware.

    I'm using vcenter on vcenter I've created two hosts where each host is having two windows vms.

    "Help create a script to find vms in a vcenter where vmtools not installed and install them without rebooting them"

    a) finding "windows" vms in a vcenter where vmtools are not installed
    b) install vmtools on them without rebooting the vm after installing it.

    Both should be in the same script.

    The script for the above line or Help me how to connect remotely to vm using Invoke-Command.It would mean a lot if you help me out

    • #95642

      Participant
      Points: 0
      Rank: Member

      Hi Varna,

      You need the VMware powercli modules for that as you cannot use invoke-command to a remote esxi machine. Just use the get-vm to get all the machines and find a property that indicates the existence of the VMware tools. I'm pretty sure there's a way to remotely install the VMware tools next via the VMware interface itself.

      Have fun!

The topic ‘Invoke-Command on remote isolated VM’ is closed to new replies.