Welcome › Forums › DSC (Desired State Configuration) › xNetworking - set multiple IP addresses?
This topic contains 1 reply, has 2 voices, and was last updated by
Is it possible to set multiple IP Addresses on an Interface using the xIPAddress resource? Something like this:
IPAddress = @('192.168.10.10','192.168.10.11')
InterfaceAlias = 'Ethernet'
PrefixLength = 24
AddressFamily = 'IPV4'
I haven't had any luck with something like that so I'm not sure if it's possible.
I don't believe so. But it's open source and that should be a fairly trivial change. Jump on in and add it!
The topic ‘xNetworking - set multiple IP addresses?’ is closed to new replies.